1. Insert a cube

1. Make the height 5mm and width 60 mm

(click on the square on the sides and change the dimensions)

1. Drag a “Hole” Cylinder

1. Size it to about 5 mm diameter

1. Position it near one short end (use the Align tool later) and raise it so half the hole sits inside the keychain: set its Z (height) to 20 mm so it cuts through.

1. Select both base and cylinder and Group (Ctrl/Cmd+G) to subtract the hole.

1. Drag the Text object onto the workplane.
2. Resize the text in X and Y to fit—play with width until it looks balanced on the keychain.

1. In the Text inspector, type your name. Choose font if available.

1. Embossed text: leave text as Solid, select both text + base → Group to permanently join (this merges geometry so text prints as part of the base).

1. Engraved text: set text to Hole before grouping; select both → Group to subtract and leave an engraved text recess.